#Audi vcds coding mod
So you don’t have to change everything else back to US measurements.Ĭomfort Blinkers set from 2 to 5, 4 is stockīyte 0 Bit 5 uncheck Rain Sensor inactiveīyte 4 Bit 5 checked Comfort op via rain sensorīyte 4 Bit 6 checked comfort op via rain sensor activeĬhina VCDS Headlight thread change recommendationsīyte 15 Bit 5 checked Parking Lights OFF with Terminal S OFF and light switch at Low beamīyte 15 Bit 6 checked DRL via separate Lights activeīyte 15 Bit 7 checked DRL Adaptation active (MFA+)īyte 19 Bit 0-3 Headlight extension inactiveīyte 27 Bit 2 checked LED-DRL Mod for Parking/Position light & DRL You can have that pleasant chime by going toġ7-Instruments->Adaptation->Seat Belt Warning - Version 3Īnd you are not warned when you go over 74mph! I dug into this and believe that the sender in the tank has a normal operation range of 70O -> 270O. Lowering the value to -10*, makes the needle lower by approx. Increasing the value to 10*, makes the needle raise by approx. The total range of fuel gauge movement was near 1/8th tank. "Display correction of fuel gauge" found in Adaptation, from the instrument cluster.īy default, this was set to 0.0*. If you wanted to Increase the Mpg on the display, lower the Adaptation value to 95% -> 98%.
![audi vcds coding audi vcds coding](https://cdn.snsimg.carview.co.jp/minkara/note/000/003/582/948/3582948/p5.jpg)
So, If you want to lower the average MPG displayed on the dash, try increasing the adaptation value to 102% -> 105%. Increasing the adaptation value lowered the Mpg data displayed on the MFA. The value should be 100% from the factory. "Display correction of consumptions and operating range" found in Adaptation, from the instrument cluster. The Instrument cluster adaptation results are: Sub-System RLS (from the drop-down menu) using Coding, Long Coding Helper Central Electronics module using Coding, Long Coding Helperīyte 4 Comfort Operation Windows/Sunroof via Rain Sensor must be enabledīyte 4 Comfort Operation Windows/Sunroof via Rain Sensor (Rain Closing) active must be enabled
![audi vcds coding audi vcds coding](https://www.car-auto-repair.com/wp-content/uploads/2019/11/Audi-A3-Drive-School-Mode-Speed-Display-Coding-by-VCDS-2.jpg)
This will require coding the master - Central Electronics module and the Sub-System RLS.
![audi vcds coding audi vcds coding](https://cdn.snsimg.carview.co.jp/minkara/note/000/001/474/782/1474782/p7.jpg)
If there is no drop down menu in Coding then you likely have no RLS. RLS may not be present on some 2013 models. I am not responsible if you do something that will cause a malfunction on your car. Some may not work on your vehicle and may require your vehicle to have equipment that may not be on yours. I have done and use many of these different tweaks. I found some in Audi forums, Golf forums and other VW forums. After I got my 2015 Passat I did a lot of searching for different little tweaks to be done on the car.